CAD CAM EDM DRO - Yahoo Group Archive

CAT 5 wiring

Posted by Joe Vicars
on 2001-04-06 15:14:35 UTC
Is there a reason not to use CAT 5, 8 twisted pair cable (ethernet) for
wiring the signal wires from the parallel port to the drivers (I.E. the
TTL level signals, step, dir, etc.)
Can you solder it without problems?
???????

Discussion Thread

Joe Vicars 2001-04-06 15:14:35 UTC CAT 5 wiring JanRwl@A... 2001-04-06 19:36:10 UTC Re: [CAD_CAM_EDM_DRO] CAT 5 wiring Jon Elson 2001-04-06 21:27:13 UTC Re: [CAD_CAM_EDM_DRO] CAT 5 wiring Woody 2001-04-07 07:57:50 UTC Re: [CAD_CAM_EDM_DRO] CAT 5 wiring Tim Goldstein 2001-04-07 09:19:44 UTC RE: [CAD_CAM_EDM_DRO] CAT 5 wiring Tom Benedict 2001-04-07 11:09:49 UTC Re: [CAD_CAM_EDM_DRO] CAT 5 wiring tony@j... 2001-04-07 14:57:42 UTC Re: CAT 5 wiring JanRwl@A... 2001-04-07 19:28:32 UTC Re: [CAD_CAM_EDM_DRO] CAT 5 wiring Randy Gordon-Gilmore 2001-04-07 19:34:49 UTC Tinnability, was Re: CAT 5 wiring JanRwl@A... 2001-04-07 19:54:10 UTC Re: [CAD_CAM_EDM_DRO] Tinnability, was Re: CAT 5 wiring Dennis Cranston 2001-04-07 20:01:50 UTC RE: [CAD_CAM_EDM_DRO] CAT 5 wiring William Scalione 2001-04-07 20:41:46 UTC Re: [CAD_CAM_EDM_DRO] CAT 5 wiring Jon Elson 2001-04-07 20:45:43 UTC Re: [CAD_CAM_EDM_DRO] Tinnability, was Re: CAT 5 wiring dave engvall 2001-04-08 11:58:28 UTC Re: [CAD_CAM_EDM_DRO] CAT 5 wiring