Re: [CAD_CAM_EDM_DRO] CAT 5 wiring
Posted by
Woody
on 2001-04-07 07:57:50 UTC
> Is there a reason not to use CAT 5, 8 twisted pair cable (ethernet) forBe very careful with stripping & strain relief. Small solid wires wont
> wiring the signal wires from the parallel port to the drivers (I.E. the
> TTL level signals, step, dir, etc.)
> Can you solder it without problems?
> ???????
deal with a lot of mechanical strain & flexure without breaking.
-G
_________________________________________________________
Do You Yahoo!?
Get your free @... address at http://mail.yahoo.com
Discussion Thread
Joe Vicars
2001-04-06 15:14:35 UTC
CAT 5 wiring
JanRwl@A...
2001-04-06 19:36:10 UTC
Re: [CAD_CAM_EDM_DRO] CAT 5 wiring
Jon Elson
2001-04-06 21:27:13 UTC
Re: [CAD_CAM_EDM_DRO] CAT 5 wiring
Woody
2001-04-07 07:57:50 UTC
Re: [CAD_CAM_EDM_DRO] CAT 5 wiring
Tim Goldstein
2001-04-07 09:19:44 UTC
RE: [CAD_CAM_EDM_DRO] CAT 5 wiring
Tom Benedict
2001-04-07 11:09:49 UTC
Re: [CAD_CAM_EDM_DRO] CAT 5 wiring
tony@j...
2001-04-07 14:57:42 UTC
Re: CAT 5 wiring
JanRwl@A...
2001-04-07 19:28:32 UTC
Re: [CAD_CAM_EDM_DRO] CAT 5 wiring
Randy Gordon-Gilmore
2001-04-07 19:34:49 UTC
Tinnability, was Re: CAT 5 wiring
JanRwl@A...
2001-04-07 19:54:10 UTC
Re: [CAD_CAM_EDM_DRO] Tinnability, was Re: CAT 5 wiring
Dennis Cranston
2001-04-07 20:01:50 UTC
RE: [CAD_CAM_EDM_DRO] CAT 5 wiring
William Scalione
2001-04-07 20:41:46 UTC
Re: [CAD_CAM_EDM_DRO] CAT 5 wiring
Jon Elson
2001-04-07 20:45:43 UTC
Re: [CAD_CAM_EDM_DRO] Tinnability, was Re: CAT 5 wiring
dave engvall
2001-04-08 11:58:28 UTC
Re: [CAD_CAM_EDM_DRO] CAT 5 wiring