Re: [CAD_CAM_EDM_DRO] Tramming the Head
Posted by
Matt Shaver
on 2001-04-09 15:37:48 UTC
Ian Wright wrote:
phrase "tramming the head" comes.
Here's a link to a very nice one:
http://www.smtco.com/trammel.htm
Matt
> Easy way to tell how true the head is - get a piece of stiff wire and bendThe wire you describe is a version of a trammel point, from which the
> one end up, the other down like so:
> |
> |
> |_______________
> |
> |
> |
> Hold the top end in the chuck / toolholder and bring the other end down to
> just above the table. Now rotate the chuck slowly by hand and you will see
> quite easily whether the head is at right angles to the table. To put
> 'figures' to it, arrange a dial gauge on a bent rod in the same way. Use as
> long a horizontal section as your table will allow so it magnifies the
> errors. I've seen old timers set up big milling machines this way using
> feeler strips under the end of the wire to check when they got things
> exactly right.
phrase "tramming the head" comes.
Here's a link to a very nice one:
http://www.smtco.com/trammel.htm
Matt
Discussion Thread
george@f...
2001-04-09 12:43:51 UTC
Tramming the Head
wanliker@a...
2001-04-09 13:49:43 UTC
Re: [CAD_CAM_EDM_DRO] Tramming the Head
Jon Elson
2001-04-09 14:32:38 UTC
Re: [CAD_CAM_EDM_DRO] Tramming the Head
stratton@m...
2001-04-09 14:58:12 UTC
Re: [CAD_CAM_EDM_DRO] Tramming the Head
Ian Wright
2001-04-09 15:08:21 UTC
Re: [CAD_CAM_EDM_DRO] Tramming the Head
Smoke
2001-04-09 15:19:40 UTC
Re: [CAD_CAM_EDM_DRO] Tramming the Head
Matt Shaver
2001-04-09 15:37:48 UTC
Re: [CAD_CAM_EDM_DRO] Tramming the Head