CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Accu-Rite III DRO

Posted by diazden
on 2001-04-09 21:36:15 UTC
Does this thing has a keypad?
if so and if after power up the digits are blinking just press the axis letter that you
want to initialise and after the incr key ( this works on anilam dro) compatible with
acurite
hope this helps
mariano


JanRwl@... wrote:

> In a message dated 08-Apr-01 20:52:38 Central Daylight Time, bheuver@...
> writes:
>
> > Does anyone know what the common failure on these is? Are they
> > worth spending any time on, or am I best just to junk it, and use one
> >
>
> No clue what "common failure" is on those. But take a DVM and probe around
> to see if the Vcc is OK (usually 5 VDC, and maybe some 12 VDC, etc., for the
> readout, if other than red 7-seg. LED).
>
> Probably not, but POSSIBLE the Vcc has lost its regulator, and gone "high",
> to maybe +8 to +15 VDC, which would probably cook ALL the 5-V. logic IC's.
>
> PC's are cheap, often free, these days, for old ones, and a '386 will perform
> vastly more wonders than just counting like a DRO! But you gotta be a bit of
> a nerdtinkerer to make use of that fact. Lotsa luck!
>
> Duh...
>
> [Non-text portions of this message have been removed]
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
> FAQ: http://www.ktmarketing.com/faq.html
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/

Discussion Thread

bheuver@f... 2001-04-08 18:50:26 UTC Accu-Rite III DRO dave engvall 2001-04-08 20:06:00 UTC Re: [CAD_CAM_EDM_DRO] Accu-Rite III DRO JanRwl@A... 2001-04-09 16:58:09 UTC Re: [CAD_CAM_EDM_DRO] Accu-Rite III DRO diazden 2001-04-09 21:36:15 UTC Re: [CAD_CAM_EDM_DRO] Accu-Rite III DRO Heuver, Brad (B.R.) 2001-04-10 07:15:02 UTC Re: Accu-Rite III DRO Doug Fortune 2001-04-10 07:49:28 UTC Accu-Rite III DRO