CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Subject: Taig as XZ lathe slide

on 2001-04-19 07:23:25 UTC
Brian Pitt wrote:

> there is a spindle encoder ,belt driven off the back side of the headstock
> for threading (standard) or the C axis option ($$$)

I figured it was something like this. Makes sense, I guess.

> they use a dedicated motion control card on a PC mainboard
> in the control ,the software is next to useless without that card
> so they dont need to lock it
> the whole system boots from one floppy and loads into a ram disk
> the part programs are stored on the 2nd floppy drive

That's interesting. The talent on this list suggests they have a
problem and don't know it.

Thanks,

JerryK

Discussion Thread

Nicholas Carter and Felice Luftschein 2001-04-18 09:15:48 UTC Subject: Taig as XZ lathe slide Brian Pitt 2001-04-18 11:22:28 UTC Re: [CAD_CAM_EDM_DRO] Subject: Taig as XZ lathe slide Joe Vicars 2001-04-18 11:26:28 UTC Re: [CAD_CAM_EDM_DRO] Subject: Taig as XZ lathe slide dougrasmussen@c... 2001-04-18 18:18:42 UTC Re: Subject: Taig as XZ lathe slide Jerry Kimberlin 2001-04-18 18:24:30 UTC Re: [CAD_CAM_EDM_DRO] Subject: Taig as XZ lathe slide Brian Pitt 2001-04-18 23:44:47 UTC Re: [CAD_CAM_EDM_DRO] Subject: Taig as XZ lathe slide Joe Vicars 2001-04-19 06:40:15 UTC Re: [CAD_CAM_EDM_DRO] Re: Subject: Taig as XZ lathe slide Jerry Kimberlin 2001-04-19 07:23:25 UTC Re: [CAD_CAM_EDM_DRO] Subject: Taig as XZ lathe slide Smoke 2001-04-19 09:32:32 UTC Re: [CAD_CAM_EDM_DRO] Re: Subject: Taig as XZ lathe slide