Re: [CAD_CAM_EDM_DRO] Kurt Drawbar Won't work!

If the Button is electric then use your multitester to trace the problem.
Switch dead. Line broken. Solenoid burnt.
If it is electrical ok then dump your pneumatic stuff for a few hours into
kerosene, terpentin, aguaras, or diesel or what ever solvent that would not effect the
seals but does soften or remove resin. Most oils turn into resin when the get old.
One of the oils that would not do it and does resolve resin is ESSO SPINESSO iso 10.
I use it gallon wise.
Good Luck
Sven Peter

jvicars@... wrote:

> Has anyone any experience with diagnosing a problem with a Kurt Power
> Drawbar? I hook up air, push the IN and OUT buttons and nothing
> happens.
> There is only the IN/OUT button, the Impact Wrench part, and a small
> air logic module. The problem must be in one of these.
> Any help?
> Thanks
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
> FAQ: http://www.ktmarketing.com/faq.html
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/

[Non-text portions of this message have been removed]