Re: Help: Drilling precise holes
Posted by
jvicars@c...
on 2001-04-30 18:09:47 UTC
Approaches I would recommend.
1. Build a temporary long table on your drill press out of 3/4"
plywood, supported to the floor. Even the smallest drill press is
better than trying to drill into 1/2" steel by hand.
2. Rent or borrow a magnetic base drill. I have a welding shop that
I frequent and they let me have theirs for 10 bucks a day. If you go
to a rental place it will be 30 to 50 bucks a day. But, believe me it
is worth it if you have any more than a couple of holes.
3. Take it to a shop with all the locations layed out and
center-punched. It might be cheaper than the Rental.
4. Find somebody on the list with a mill, or large drill press, and
get it done pro-bono. Where are you located?
1. Build a temporary long table on your drill press out of 3/4"
plywood, supported to the floor. Even the smallest drill press is
better than trying to drill into 1/2" steel by hand.
2. Rent or borrow a magnetic base drill. I have a welding shop that
I frequent and they let me have theirs for 10 bucks a day. If you go
to a rental place it will be 30 to 50 bucks a day. But, believe me it
is worth it if you have any more than a couple of holes.
3. Take it to a shop with all the locations layed out and
center-punched. It might be cheaper than the Rental.
4. Find somebody on the list with a mill, or large drill press, and
get it done pro-bono. Where are you located?
Discussion Thread
Dan
2001-04-30 16:52:34 UTC
Help: Drilling precise holes
jvicars@c...
2001-04-30 18:09:47 UTC
Re: Help: Drilling precise holes
Dan
2001-04-30 20:25:08 UTC
Re: [CAD_CAM_EDM_DRO] Re: Help: Drilling precise holes
Smoke
2001-04-30 20:49:50 UTC
Re: [CAD_CAM_EDM_DRO] Help: Drilling precise holes
Dan Mauch
2001-05-01 08:51:32 UTC
Re: [CAD_CAM_EDM_DRO] Help: Drilling precise holes
Dan
2001-05-03 09:26:45 UTC
Re: [CAD_CAM_EDM_DRO] Help: Drilling precise holes
Tim Goldstein
2001-05-03 10:03:55 UTC
RE: [CAD_CAM_EDM_DRO] Help: Drilling precise holes
Dan Mauch
2001-05-03 10:43:04 UTC
Re: [CAD_CAM_EDM_DRO] Help: Drilling precise holes
Dan Mauch
2001-05-03 10:52:07 UTC
Re: [CAD_CAM_EDM_DRO] Help: Drilling precise holes
jguenther@l...
2001-05-03 11:07:04 UTC
Re: Help: Drilling precise holes
ballendo@y...
2001-05-05 04:01:49 UTC
Re: Help: Drilling precise holes