Re: [CAD_CAM_EDM_DRO] Re: Sheet metal Cad

Hi!

There are a good freeware program called Cone (www.pulserate.com)

Can make cones, tubes with different angles on both ends..

----- Original Message -----
From: "Tom Eldredge" <harmonyt@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Monday, May 21, 2001 2:50 AM
Subject: Re: [CAD_CAM_EDM_DRO] Re: Sheet metal Cad


> Jeff, Fred, Smoke, "machines", Doug, and Jerry,
>
> Thank you very much for taking the time to answer my querry regarding sheet
> metal CAD. I am studying all of the good alternatives you proposed, and
> will let you know what I decide to do. I do not need the ability to design
> complex shapes, just things like cones, and also, I remembered that I will
> need to design for sheet metal tubes which connect into the sides of the
> cones at angles, to produce the swirling motion inside the cone.
>
> I should have looked through the great book selection at NAMES for an old
> sheet metal design book. I don't have any yet.
>
> Thanks again, gentlemen.
>
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the discussion of shop built systems, for CAD, CAM, EDM, and DRO.
>
> Addresses:
> Post message: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
> FAQ: http://www.ktmarketing.com/faq.html
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>