Re: [CAD_CAM_EDM_DRO] cutting mirror

I found thru experimenting that I could mount a HSS cutter in my hand held
air grinder (runs about 300,000 RPM)
that I couold carve designs right in the glass. didn't have any problems
whatsoever. However, when doing this you need to be careful to wear a face
mask and eye protection.

Smoke

>Is it possible to mill mirror?
>If so, how?
>
>T.I.A.
>Geo.
>
>
>Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the

discussion of shop built systems, for CAD, CAM, EDM, and DRO.

>
>Addresses:
>Post message: CAD_CAM_EDM_DRO@yahoogroups.com
>Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
>Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
>List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
>Moderator: jmelson@... timg@... [Moderator]
>URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
>bill,
>List Manager
>
>FAQ: http://www.ktmarketing.com/faq.html
>
>Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>