CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Lubrication for CNC

on 2001-05-24 20:26:27 UTC
Jon Elson wrote:

>
> I still haven't figured out what to lube thwe ball screws with. They had a black grease
> in them, so I'm thinking a Moly grease would be in order.
>
> Jon
>

Hello Jon,
personally I prefer in environments were chips are always oil and no grease.
Grease tends to pick up debrids and carry them into the working parts,
where they make a lot of damage. I recommend you filtered way oil.
Good Luck
Sven Peter

PS. this post comes a little late because I clean up my inbox.


[Non-text portions of this message have been removed]

Discussion Thread

wanliker@a... 2001-05-09 13:06:02 UTC Lubrication for CNC Bill Griffin 2001-05-09 13:51:18 UTC Re: Lubrication for CNC Rich D. 2001-05-09 17:05:36 UTC Re: [CAD_CAM_EDM_DRO] Lubrication for CNC Carol & Jerry Jankura 2001-05-09 17:18:20 UTC RE: [CAD_CAM_EDM_DRO] Lubrication for CNC Sven Peter, TAD S.A. 2001-05-09 18:51:09 UTC Re: [CAD_CAM_EDM_DRO] Lubrication for CNC wanliker@a... 2001-05-09 19:17:15 UTC Re: [CAD_CAM_EDM_DRO] Re: Lubrication for CNC Rich D. 2001-05-09 19:28:06 UTC Re: [CAD_CAM_EDM_DRO] Lubrication for CNC David Volosky 2001-05-09 22:14:20 UTC Lubrication for CNC ballendo@y... 2001-05-10 05:00:29 UTC Re: Lubrication for CNC Lee Studley 2001-05-10 20:48:23 UTC Felt Way wipers on SEriesII ok.??.. was Re: Lubrication for CNC Jon Elson 2001-05-13 23:41:23 UTC Re: [CAD_CAM_EDM_DRO] Lubrication for CNC Sven Peter, TAD S.A. 2001-05-24 20:26:27 UTC Re: [CAD_CAM_EDM_DRO] Lubrication for CNC