RF-31
Posted by
Peter Chen
on 2001-05-28 17:17:48 UTC
From: Alan Marconett KM6VV <KM6VV@...>:I plan to
try some old NEMA
#34 S/S 300 oz/in motors on my new RF-31 mill, with
3:1 drives, even
though their not really big enough! I will put on
bigger steppers when
I can afford them! For now, I'll even leave the Acme
lead screws!"
Hi Alan,
Do you have any photo of your RF-31 posted anywhere on
the web?
Is there any possibility of making a motor mount for
the RF-31?
Perhaps some may want to make motor mounts for the
RF-31 for sale?
If one use indirect drive, how can one mount the motor
to the table/slide
and how would one take out the hand wheels to replace
with toothed wheels?
Hope this is not asking too much.
Peter
____________________________________________________________
Do You Yahoo!?
Get your free @... address at http://mail.yahoo.co.uk
or your free @... address at http://mail.yahoo.ie
try some old NEMA
#34 S/S 300 oz/in motors on my new RF-31 mill, with
3:1 drives, even
though their not really big enough! I will put on
bigger steppers when
I can afford them! For now, I'll even leave the Acme
lead screws!"
Hi Alan,
Do you have any photo of your RF-31 posted anywhere on
the web?
Is there any possibility of making a motor mount for
the RF-31?
Perhaps some may want to make motor mounts for the
RF-31 for sale?
If one use indirect drive, how can one mount the motor
to the table/slide
and how would one take out the hand wheels to replace
with toothed wheels?
Hope this is not asking too much.
Peter
____________________________________________________________
Do You Yahoo!?
Get your free @... address at http://mail.yahoo.co.uk
or your free @... address at http://mail.yahoo.ie
Discussion Thread
Peter Chen
2001-05-28 17:17:48 UTC
RF-31
Alan Marconett KM6VV
2001-05-28 18:44:03 UTC
Re: [CAD_CAM_EDM_DRO] RF-31
cadcamcenter@y...
2001-05-28 20:16:52 UTC
Re: RF-31
cadcamcenter@y...
2001-05-28 20:40:25 UTC
Re: RF-31
Garry & Maxine Foster
2001-05-29 05:40:53 UTC
Re: [CAD_CAM_EDM_DRO] RF-31
cadman@p...
2001-05-29 12:13:44 UTC
Re: RF-31
Alan Marconett KM6VV
2001-05-29 13:10:42 UTC
Re: [CAD_CAM_EDM_DRO] Re: RF-31
Alan Marconett KM6VV
2001-05-29 13:18:02 UTC
Re: [CAD_CAM_EDM_DRO] Re: RF-31
Alan Marconett KM6VV
2001-05-29 13:38:09 UTC
Re: [CAD_CAM_EDM_DRO] RF-31