Re: [CAD_CAM_EDM_DRO] Re: Tapping into the group knowledge - DRO

Peter:

At the moment no, but I am looking into the possibility of adding DRO to
Master5, but with the commitments I have it will probably not be until
Master6 that DRO will be implemented.

Art

----- Original Message -----
From: <cadcamcenter@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Friday, June 29, 2001 9:27 AM
Subject: [CAD_CAM_EDM_DRO] Re: Tapping into the group knowledge - DRO


> "Art Fenerty" <fenerty@h...> wrote: "Well, I couldn't help myself, I
> had to check. The optical mouse IC specs are on the below link. It is
> a 400cpi quadrature encoder which can be used at 12 inches per
> second. Maybe too low a resolution? Mayeb there's a way to make a
> dual sliding assembly to double its true resolution. Sounds like a
> real cheap way to make a pretty good hobby DRO."
>
> > http://www2.taconuts.com/articles/2000/12/3/hdns2000.pdf
>
> Hi Art
>
> Is there a way to feed the signals to Master5 and to compare "what
> is" and "what should be"? And for Master5 to issue a signal
> when "what is" is not equal to "what should be"?
>
> Thanks,
>
> Peter
>
>
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>