CAD CAM EDM DRO - Yahoo Group Archive

laser transit

Posted by Doug Harrison
on 2001-06-30 12:47:27 UTC
I have a laser transit I would like to use for levelling the ways of my router table. It is self levelling and accurate to better than .001 in/ft. However, I am unable to come up with a means of detecting surface height to this accuracy over short distances (120 inches).

Does anyone have ideas on how to utilize the laser beam, short of spending a fortune on an autocollimator lens system?

Doug


[Non-text portions of this message have been removed]

Discussion Thread

Doug Harrison 2001-06-30 12:47:27 UTC laser transit JanRwl@A... 2001-06-30 13:40:32 UTC Re: [CAD_CAM_EDM_DRO] laser transit Doug Harrison 2001-06-30 13:55:23 UTC Re: [CAD_CAM_EDM_DRO] laser transit Jon Elson 2001-06-30 17:26:13 UTC Re: [CAD_CAM_EDM_DRO] laser transit Jon Elson 2001-06-30 17:30:20 UTC Re: [CAD_CAM_EDM_DRO] laser transit JanRwl@A... 2001-06-30 17:36:57 UTC Re: [CAD_CAM_EDM_DRO] laser transit Fitch R. Williams 2001-06-30 18:42:48 UTC Re: [CAD_CAM_EDM_DRO] laser transit Doug Harrison 2001-07-01 07:42:11 UTC Re: [CAD_CAM_EDM_DRO] laser transit Doug Harrison 2001-07-01 07:53:36 UTC Re: [CAD_CAM_EDM_DRO] laser transit Tim Goldstein 2001-07-01 11:01:09 UTC RE: [CAD_CAM_EDM_DRO] laser transit Jon Elson 2001-07-01 11:34:03 UTC Re: [CAD_CAM_EDM_DRO] laser transit Doug Harrison 2001-07-01 17:44:42 UTC Re: [CAD_CAM_EDM_DRO] laser transit Jon Elson 2001-07-01 22:20:16 UTC Re: [CAD_CAM_EDM_DRO] laser transit