Re: [CAD_CAM_EDM_DRO] laser transit
Posted by
Jon Elson
on 2001-07-01 11:34:03 UTC
Doug Harrison wrote:
one design of which has a gantry that travels on two widely separated
tracks.
How are you going to keep the two sides of the gantry in sync?
Jon
> > Hmm, you don't actually say lathe there, is this a bed mill?OK, well, sounds like it may be similar in construction to a bed mill,
>
> It's a router table.
one design of which has a gantry that travels on two widely separated
tracks.
How are you going to keep the two sides of the gantry in sync?
Jon
Discussion Thread
Doug Harrison
2001-06-30 12:47:27 UTC
laser transit
JanRwl@A...
2001-06-30 13:40:32 UTC
Re: [CAD_CAM_EDM_DRO] laser transit
Doug Harrison
2001-06-30 13:55:23 UTC
Re: [CAD_CAM_EDM_DRO] laser transit
Jon Elson
2001-06-30 17:26:13 UTC
Re: [CAD_CAM_EDM_DRO] laser transit
Jon Elson
2001-06-30 17:30:20 UTC
Re: [CAD_CAM_EDM_DRO] laser transit
JanRwl@A...
2001-06-30 17:36:57 UTC
Re: [CAD_CAM_EDM_DRO] laser transit
Fitch R. Williams
2001-06-30 18:42:48 UTC
Re: [CAD_CAM_EDM_DRO] laser transit
Doug Harrison
2001-07-01 07:42:11 UTC
Re: [CAD_CAM_EDM_DRO] laser transit
Doug Harrison
2001-07-01 07:53:36 UTC
Re: [CAD_CAM_EDM_DRO] laser transit
Tim Goldstein
2001-07-01 11:01:09 UTC
RE: [CAD_CAM_EDM_DRO] laser transit
Jon Elson
2001-07-01 11:34:03 UTC
Re: [CAD_CAM_EDM_DRO] laser transit
Doug Harrison
2001-07-01 17:44:42 UTC
Re: [CAD_CAM_EDM_DRO] laser transit
Jon Elson
2001-07-01 22:20:16 UTC
Re: [CAD_CAM_EDM_DRO] laser transit