CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] DC Surplus Motors

Posted by Rich D.
on 2001-07-19 09:57:42 UTC
David,
All of these treadmill motors and controllers that have been yacked about
over the last few years come from The Surplus Center in Lincoln, Neb.
800-488-3407. Only the 90V DC permag with controller is available now as
a set and is item no. 10-1806. 2.5 HP, 115VAC input, 18A, 0-6750 rpm.
RichD


"David M. Munro" wrote:
>
> Can you point us at the vendor? A search for "Surplus Sales" doesen't seem to
> turn up anything relevant.
>
> David M. Munro
>
> Chris Difani wrote:
>
> > I rebuilt my 16 inch bench top drill press with the 90-130VDC 2.5HP
> > treadmill motor from Surplus Sales ($49.95 plus shipping, came to $62.00
> > total), and it is superior in all respects to the original motor/drive
> > system that was on my 'press.

Discussion Thread

Chris Difani 2001-07-18 18:06:13 UTC DC Surplus Motors David M. Munro 2001-07-19 05:25:04 UTC Re: [CAD_CAM_EDM_DRO] DC Surplus Motors deanc500@y... 2001-07-19 08:02:42 UTC Re: DC Surplus Motors Rich D. 2001-07-19 09:57:42 UTC Re: [CAD_CAM_EDM_DRO] DC Surplus Motors Jon Elson 2001-07-19 11:08:01 UTC Re: [CAD_CAM_EDM_DRO] DC Surplus Motors Drew Rogge 2001-07-19 11:29:49 UTC Re: [CAD_CAM_EDM_DRO] DC Surplus Motors Alan Marconett KM6VV 2001-07-19 12:35:55 UTC Re: [CAD_CAM_EDM_DRO] DC Surplus Motors Rich D. 2001-07-19 12:41:39 UTC Re: [CAD_CAM_EDM_DRO] DC Surplus Motors Rich D. 2001-07-19 12:45:08 UTC Re: [CAD_CAM_EDM_DRO] DC Surplus Motors Alan Marconett KM6VV 2001-07-19 13:02:38 UTC Re: [CAD_CAM_EDM_DRO] DC Surplus Motors Drew Rogge 2001-07-19 13:40:01 UTC Re: [CAD_CAM_EDM_DRO] DC Surplus Motors mdickey@b... 2001-07-19 15:36:23 UTC Re: DC Surplus Motors Rich D. 2001-07-19 16:27:19 UTC Re: [CAD_CAM_EDM_DRO] Re: DC Surplus Motors Ron Yost 2001-07-19 18:31:12 UTC Re: [CAD_CAM_EDM_DRO] DC Surplus Motors mslov.joy@v... 2001-07-19 18:58:10 UTC Re: DC Surplus Motors Carlos Guillermo 2001-07-20 07:47:18 UTC Re: DC Surplus Motors