Re: [CAD_CAM_EDM_DRO] Re: CAM Expert software

First I must apologize for not keeping up with all the posts
on the list. I have only time to take note of the odd post and
so my question, without knowing the real story,: Is there a
bigger / better manual then the 168 page "learning Vector in
2 hours" that I received with my Vector 9 package??? If so,
is it on line or something that I can purchase.

Thanks in advance

Bill Darby

PS I think Vector is great.

Fred Smith wrote:

>
> --- In CAD_CAM_EDM_DRO@y..., alenz@c... wrote:
> > Alan,
>
> >But seriously, the manual looks to be really
> > good, a BIG plus for Vector!
> >
> > Is ths an easy parameter to set, or can you direct me to the
> > section of the manual that covers this, (so I can print it out)?
>
> See manual page 350 for special DXF settings. You can also Change-
> Break interpolate any arc into lines if your machine controller has a
> problem with standard G-code arcs.
>
> Best Regards,
>
> Fred Smith
> IMService
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/