Re: "nice numbers" for lead, window EMC dual boot, and the gotcha's
Posted by
daque@s...
on 2001-08-12 20:43:51 UTC
...
> An alternative to ballscrews is to use good acme screws and castthe nuts
> using Moglice or some home brew imitation. If you are going to putthese on
> an Enco XY table this is probably all you really need.Where do you buy Moglice, is it very expensive?
>
> Doug
Discussion Thread
David E. Queen
2001-08-12 13:41:15 UTC
"nice numbers" for lead, window EMC dual boot, and the gotcha's
Jon Elson
2001-08-12 15:39:18 UTC
Re: [CAD_CAM_EDM_DRO] "nice numbers" for lead, window EMC dual boot, and the gotcha's
Doug Harrison
2001-08-12 16:08:53 UTC
Re: [CAD_CAM_EDM_DRO] "nice numbers" for lead, window EMC dual boot, and the gotcha's
Paul
2001-08-12 16:40:25 UTC
Re: [CAD_CAM_EDM_DRO] "nice numbers" for lead, window EMC dual boot, and the gotcha's
daque@s...
2001-08-12 20:43:51 UTC
Re: "nice numbers" for lead, window EMC dual boot, and the gotcha's
Dr Brian H Le Page
2001-08-13 00:31:41 UTC
RE: [CAD_CAM_EDM_DRO] "nice numbers" for lead, window EMC dual boot, and the gotcha's
Larry Van Duyn
2001-08-13 05:50:25 UTC
Re: [CAD_CAM_EDM_DRO] Re: "nice numbers" for lead, window EMC dual boot, and the gotcha's
Dan Mauch
2001-08-13 07:28:26 UTC
RE: [CAD_CAM_EDM_DRO] "nice numbers" for lead, window EMC dual boot, and the gotcha's
Tim
2001-08-13 08:48:39 UTC
RE: [CAD_CAM_EDM_DRO] "nice numbers" for lead, window EMC dual boot, and the gotcha's
Joel Jacobs
2001-08-13 11:18:05 UTC
Re: [CAD_CAM_EDM_DRO] "nice numbers" for lead, window EMC dual boot, and the gotcha's