CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Re: "nice numbers" for lead, window EMC dual boot, and the gotcha's

on 2001-08-13 05:50:25 UTC
daque@... wrote:

> ...
> > An alternative to ballscrews is to use good acme screws and cast
> the nuts
> > using Moglice or some home brew imitation. If you are going to put
> these on
> > an Enco XY table this is probably all you really need.
> >
> > Doug
>
> Where do you buy Moglice, is it very expensive?
>

Devitt Machinery Company...
800-749-3135

They will send, upon request, data on the whole Moglice line of products..

Discussion Thread

David E. Queen 2001-08-12 13:41:15 UTC "nice numbers" for lead, window EMC dual boot, and the gotcha's Jon Elson 2001-08-12 15:39:18 UTC Re: [CAD_CAM_EDM_DRO] "nice numbers" for lead, window EMC dual boot, and the gotcha's Doug Harrison 2001-08-12 16:08:53 UTC Re: [CAD_CAM_EDM_DRO] "nice numbers" for lead, window EMC dual boot, and the gotcha's Paul 2001-08-12 16:40:25 UTC Re: [CAD_CAM_EDM_DRO] "nice numbers" for lead, window EMC dual boot, and the gotcha's daque@s... 2001-08-12 20:43:51 UTC Re: "nice numbers" for lead, window EMC dual boot, and the gotcha's Dr Brian H Le Page 2001-08-13 00:31:41 UTC RE: [CAD_CAM_EDM_DRO] "nice numbers" for lead, window EMC dual boot, and the gotcha's Larry Van Duyn 2001-08-13 05:50:25 UTC Re: [CAD_CAM_EDM_DRO] Re: "nice numbers" for lead, window EMC dual boot, and the gotcha's Dan Mauch 2001-08-13 07:28:26 UTC RE: [CAD_CAM_EDM_DRO] "nice numbers" for lead, window EMC dual boot, and the gotcha's Tim 2001-08-13 08:48:39 UTC RE: [CAD_CAM_EDM_DRO] "nice numbers" for lead, window EMC dual boot, and the gotcha's Joel Jacobs 2001-08-13 11:18:05 UTC Re: [CAD_CAM_EDM_DRO] "nice numbers" for lead, window EMC dual boot, and the gotcha's