Re: [CAD_CAM_EDM_DRO] BDI Steppermod gives following errors

jguenthe wrote:

> I have a new problem that just started this morning. I have been happily
> running the BDI EMC setup, with the patch that came out a couple of weeks
> ago applied. Everything has been working just fine until this morning. I
> brought EMC up. every thing was kul then on the next time I started it every
> time I try to move any axis I get an error box popped up saying I have a
> following error. I changed nothing, what is causing this and how do I fix
> it?

Does the machine actually move? If not, I'm guessing that a wierd problem
that was experienced about a year ago may have popped up again.
If you have a copy of the xxx.ini file that you are using, check to see if any
of
the values in that file have changed - like to zero! I'm guessing the most
obvious cause is the P term for each axis has gotten set to zero. this
will cause no movement, and the commanded position will change, while
steppermod knows no movement has actually been made.

Jon