RE: [CAD_CAM_EDM_DRO] BDI Steppermod gives following errors

Hi Jon,

No the machine does not move. I will check the emc.ini file when I get home
and let you know what the values are.

Thanks for the info.

John

> -----Original Message-----
> From: elson [mailto:elson]On Behalf Of Jon Elson
> Sent: Thursday, August 23, 2001 2:23 PM
> To: CAD_CAM_EDM_DRO@yahoogroups.com
> Subject: Re: [CAD_CAM_EDM_DRO] BDI Steppermod gives following errors
>
>
> jguenthe wrote:
>
> > I have a new problem that just started this morning. I have
> been happily
> > running the BDI EMC setup, with the patch that came out a
> couple of weeks
> > ago applied. Everything has been working just fine until this
> morning. I
> > brought EMC up. every thing was kul then on the next time I
> started it every
> > time I try to move any axis I get an error box popped up saying I have a
> > following error. I changed nothing, what is causing this and
> how do I fix
> > it?
>
> Does the machine actually move? If not, I'm guessing that a wierd problem
> that was experienced about a year ago may have popped up again.
> If you have a copy of the xxx.ini file that you are using, check
> to see if any
> of
> the values in that file have changed - like to zero! I'm
> guessing the most
> obvious cause is the P term for each axis has gotten set to zero. this
> will cause no movement, and the commanded position will change, while
> steppermod knows no movement has actually been made.
>
> Jon
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>