R8 Snap Change
Posted by
joevicar3@h...
on 2001-09-10 20:49:21 UTC
Does anyone know how an "R8 Snap Change" quick change system works?
this system uses basically a stub end of an R8 taper as a tool holder.
I have never seen one before. I have one on a bridgeport but I don't
see how it works. There doesn't seem to be any inlet for compressed
air, although the system resembles a power drawbar.
Any help is appreciated
Joe V
this system uses basically a stub end of an R8 taper as a tool holder.
I have never seen one before. I have one on a bridgeport but I don't
see how it works. There doesn't seem to be any inlet for compressed
air, although the system resembles a power drawbar.
Any help is appreciated
Joe V
Discussion Thread
joevicar3@h...
2001-09-10 20:49:21 UTC
R8 Snap Change
joevicar3@h...
2001-09-10 20:56:26 UTC
R8 Snap Change
Ward M.
2001-09-10 21:23:48 UTC
RE: [CAD_CAM_EDM_DRO] R8 Snap Change
Eric Keller
2001-09-10 22:08:22 UTC
Re: [CAD_CAM_EDM_DRO] R8 Snap Change
David Volosky
2001-09-11 01:47:56 UTC
R8 Snap Change