Re: [CAD_CAM_EDM_DRO] Re: EMC with Stepperworld Parallel Card

Vincent - I basically just had to pull pins 14,16, and 17 to ground and it
worked. What INI file did you change, and what did you change in it? This
whole EMC thing is COMPLETELY new to me, so I'm after any learning
opportunity here!

Thanks,

Matt

-----Original Message-----
From: Vincent Chan <v7chan@...>
To: CAD_CAM_EDM_DRO@yahoogroups.com <CAD_CAM_EDM_DRO@yahoogroups.com>
Date: Thursday, September 13, 2001 12:53 PM
Subject: [CAD_CAM_EDM_DRO] Re: EMC with Stepperworld Parallel Card

>Hi Matthew,
> If this is Stepperworld's SP-3 card? If so, I have it running with EMC
>(BDI) without any changes to the pins, or anything by that matter. Just
>had to set up the .ini file.
>
>Hope this helps,
>
>Vincent.
>
>ps. in anyone is wondering, the SP-3 card is based on allegro's UND5804
>unipolar driver chip.
>
>
>Matthew King wrote:
>
>> Has anyone made EMC work with the Stepperworld Unipolar Parallel Driver
>> card? I bought their little kit (card, current limiting resistors and 3

60

>> oz motors) off of ebay a while back, just to mess with. They may find

their

>> way onto my little Atlas horizontal mill one day, but I've got to get

them

>> working first!
>
>
>
>
>Addresses:
>FAQ: http://www.ktmarketing.com/faq.html
>FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
>Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
>Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
>Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
>List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
>Moderator: jmelson@... timg@... [Moderator]
>URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
>bill,
>List Manager
>
>
>
>Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>
>