CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Re: Simple DRO sensors - Cheap !

Posted by Rick Miller
on 2001-11-08 20:13:51 UTC
> They also cary linear encoder strip, but making protective housings is
> a real pain.
Wouldn't these be the best choice for accuracy? It seems to me using data
from a linear strip would eliminate the problems arising from
ballscrew/leadscrew tolerances, or rather would allow the software to
compensate for it in a way that a rotary encoder couldn't.

My concern though is that "CPI" resolution... the highest was 360, does this
mean it would only read to 1/360 = 0.00277..... inch? As even low end
ballscrews have runouts around 0.004", it wouldn't seem to be much of an
improvement, if that is the case.

Am I making the right assumptions here?

Rick

Discussion Thread

Mark Taft 2001-09-05 01:00:23 UTC RE: [CAD_CAM_EDM_DRO] Simple DRO sensors - Cheap ! Doug Fortune 2001-09-05 05:39:25 UTC Re: [CAD_CAM_EDM_DRO] Simple DRO sensors - Cheap ! dspinnett@y... 2001-11-08 19:26:46 UTC Re: Simple DRO sensors - Cheap ! Rick Miller 2001-11-08 19:45:27 UTC Re: [CAD_CAM_EDM_DRO] Re: Simple DRO sensors - Cheap ! ccs@m... 2001-11-08 19:55:31 UTC Re: [CAD_CAM_EDM_DRO] Re: Simple DRO sensors - Cheap ! Rick Miller 2001-11-08 20:13:51 UTC Re: [CAD_CAM_EDM_DRO] Re: Simple DRO sensors - Cheap ! ccs@m... 2001-11-08 20:26:14 UTC Re: [CAD_CAM_EDM_DRO] Re: Simple DRO sensors - Cheap ! Steve Smith 2001-11-08 20:58:32 UTC Re: [CAD_CAM_EDM_DRO] Re: Simple DRO sensors - Cheap ! Jon Elson 2001-11-08 23:05:42 UTC Re: [CAD_CAM_EDM_DRO] Re: Simple DRO sensors - Cheap ! Dan Mauch 2001-11-09 06:42:32 UTC RE: [CAD_CAM_EDM_DRO] Re: Simple DRO sensors - Cheap ! Steve Smith 2001-11-09 11:44:25 UTC Re: [CAD_CAM_EDM_DRO] Re: Simple DRO sensors - Cheap !