CAD CAM EDM DRO - Yahoo Group Archive

Re: shafting question

on 2001-11-09 23:40:33 UTC
Hello,

I was also looking into a similar machine several months ago. I made
a simple Excel spreadsheet which I posted in the "Files" section.
It's called "Beam Deflection". It is very basic but it helps to get
you in the right ballpark.

Jason

--- In CAD_CAM_EDM_DRO@y..., "Rick Miller" <apollo@a...> wrote:
> Hi,
> Could anyone point me to a resource telling me how much a
certain material will bend if it is X long and has Y load applied to
it? I'm trying to decide if I can get away with using 1/2" dia. end
supported shafting on my mill or if I'm going to need continuously
supported shafting.
> I'm concerned the end-supported may bow too much under load,
causing innacuracy or leading to things binding up on me. The
continuously supported shafting though is much more expensive.
> Also, has anyone had any experience using frelon bearings?
>
> Thanks,
> Rick
>
>
>
> [Non-text portions of this message have been removed]

Discussion Thread

Rick Miller 2001-11-09 15:18:31 UTC shafting question machines@n... 2001-11-09 15:37:55 UTC Re: shafting question ccs@m... 2001-11-09 15:41:13 UTC Re: [CAD_CAM_EDM_DRO] shafting question JanRwl@A... 2001-11-09 16:02:05 UTC Re: [CAD_CAM_EDM_DRO] shafting question Rick Miller 2001-11-09 16:44:45 UTC Re: [CAD_CAM_EDM_DRO] shafting question Jon Elson 2001-11-09 21:44:13 UTC Re: [CAD_CAM_EDM_DRO] shafting question andesign2@y... 2001-11-09 23:40:33 UTC Re: shafting question ballendo@y... 2001-11-12 00:41:50 UTC Re: shafting question Rick Miller 2001-11-12 15:03:15 UTC Re: [CAD_CAM_EDM_DRO] Re: shafting question ballendo@y... 2001-11-13 15:24:13 UTC follw-up on pacific bearings was Re: shafting question Rick Miller 2001-11-13 17:05:31 UTC Re: [CAD_CAM_EDM_DRO] follw-up on pacific bearings was Re: shafting question thscarince@h... 2001-11-14 06:20:26 UTC follw-up on pacific bearings was Re: shafting question Eric Keller 2001-11-14 15:56:38 UTC Re: [CAD_CAM_EDM_DRO] follw-up on pacific bearings was Re: shafting question