Re: Help w/ Sheldon Lathe
Posted by
dougrasmussen@c...
on 2001-11-17 20:19:16 UTC
Chris,
I checked the installation instructions. It does say to install in
the correct direction.
My experience with these belts was the same situation as Gary's,
except a Logan lathe. I don't recall paying any attention to
direction when I installed. I do know that machine was run for years
in both forward and reverse. We used it for tapping over a period of
10 years. It's sold now so I can't check to see which way the belts
were oriented.
Thanks for the heads up, I'll be more careful next time.
Doug
I checked the installation instructions. It does say to install in
the correct direction.
My experience with these belts was the same situation as Gary's,
except a Logan lathe. I don't recall paying any attention to
direction when I installed. I do know that machine was run for years
in both forward and reverse. We used it for tapping over a period of
10 years. It's sold now so I can't check to see which way the belts
were oriented.
Thanks for the heads up, I'll be more careful next time.
Doug
--- In CAD_CAM_EDM_DRO@y..., ccs@m... wrote:
>
> > Instead of taking the spindle out, replace the belts with link-
type v-
> > belts. These belts are made up of links which snap together to
> > create any length belt. Link-type belts are better than
conventional
> > belts.
>
> Link belts do not work in reversing applications as they have to be
> installed with the overlapping part of the links oriented in the
> direction of rotation. See the installation instructions at
>
> http://www.fennerindustrial.com/products/pdfs/ptpinstall_new.pdf
>
> Chris
Discussion Thread
Gary Mazzaferro
2001-11-17 13:46:36 UTC
Help w/ Sheldon Lathe
dougrasmussen@c...
2001-11-17 18:08:21 UTC
Re: Help w/ Sheldon Lathe
ccs@m...
2001-11-17 18:28:14 UTC
Re: [CAD_CAM_EDM_DRO] Re: Help w/ Sheldon Lathe
JanRwl@A...
2001-11-17 19:17:28 UTC
Re: [CAD_CAM_EDM_DRO] Re: Help w/ Sheldon Lathe
dougrasmussen@c...
2001-11-17 20:19:16 UTC
Re: Help w/ Sheldon Lathe
ccs@m...
2001-11-17 20:54:10 UTC
Re: [CAD_CAM_EDM_DRO] Re: Help w/ Sheldon Lathe
Smoke
2001-11-17 21:12:13 UTC
Re: [CAD_CAM_EDM_DRO] Re: Help w/ Sheldon Lathe
Mike Chaney
2001-11-18 01:28:22 UTC
Re: [CAD_CAM_EDM_DRO] Re: Help w/ Sheldon Lathe
Gary Mazzaferro
2001-11-19 22:22:52 UTC
RE: [CAD_CAM_EDM_DRO] Re: Help w/ Sheldon Lathe