Re: [CAD_CAM_EDM_DRO] Virtual Control Panels?

Chris: See my little PCB-drill in PHOTOS. That is a VERY-small (old) Tandy
laptop. Monitor, keyboard, CPU-"box" and all, in ONE tiny package. PVC and
clear tape keep out the dust (no "hot chips", as this is for wood-turning,
but is IMMEDIATELY behind my 1340 engine-lathe which I use to MAKE this kinda
thing!). I had initially envisioned installing an old '386 in a "mini-tower"
below the lathe's bench-top, and putting a keyboad and 13" monitor "up there"
where the laptop now is (the shelf was bigger before I inherited the laptop
from a bored e-bay customer!). But I had drilled holes in the shelf for the
"feet" and cable, etc., so it would HARDLY fall off! Monitor was to be
BOLTED down. But laptop is MUCH better, as you can see!