Re: Virtual Control Panels?
Posted by
Tony Jeffree
on 2001-12-07 00:31:18 UTC
At 03:29 07/12/2001 +0000, you wrote:
the edges. If you leave the sheet a bit loose, there is enough give to
allow the keys to be depressed individually (too tight & hitting one key
also hits neighbouring keys). This works very well & is cheap to replace
when the inevitable film of grime renders the keys unreadable. The easiest
way to do this is to use polythene bags that are big enough to put the
entire keyboard inside, so the whole of the case is protected from foreign
bodies/fluids.
Regards,
Tony
>I think a good solution would be to have a PC monitor mounted over theEasy. Tape a sheet of thin polythene over the keyboard, sealing it down at
> > machine. Then I'd like the keyboard protected somehow and mounted
> > right on the front where it is very convenient. The problem is how to
> > protect it from blue-hot chips.
the edges. If you leave the sheet a bit loose, there is enough give to
allow the keys to be depressed individually (too tight & hitting one key
also hits neighbouring keys). This works very well & is cheap to replace
when the inevitable film of grime renders the keys unreadable. The easiest
way to do this is to use polythene bags that are big enough to put the
entire keyboard inside, so the whole of the case is protected from foreign
bodies/fluids.
Regards,
Tony
Discussion Thread
scyvt
2001-12-06 18:05:13 UTC
Virtual Control Panels?
ccs@m...
2001-12-06 19:04:50 UTC
Re: [CAD_CAM_EDM_DRO] Virtual Control Panels?
Sven Peter
2001-12-06 19:25:21 UTC
Re: [CAD_CAM_EDM_DRO] Virtual Control Panels?
JanRwl@A...
2001-12-06 20:13:21 UTC
Re: [CAD_CAM_EDM_DRO] Virtual Control Panels?
janrwl
2001-12-06 20:24:44 UTC
Re: Virtual Control Panels?
Jon Elson
2001-12-06 21:13:40 UTC
Re: [CAD_CAM_EDM_DRO] Virtual Control Panels?
Jerry Dees
2001-12-06 23:16:58 UTC
Re: [CAD_CAM_EDM_DRO] Virtual Control Panels?
Brian Pitt
2001-12-06 23:52:17 UTC
Re: [CAD_CAM_EDM_DRO] Virtual Control Panels?
Ward M.
2001-12-07 00:07:42 UTC
RE: [CAD_CAM_EDM_DRO] Virtual Control Panels?
Tony Jeffree
2001-12-07 00:31:18 UTC
Re: Virtual Control Panels?
Paul
2001-12-07 13:54:00 UTC
Re: [CAD_CAM_EDM_DRO] Virtual Control Panels?
Ray
2001-12-08 06:30:49 UTC
Re: Virtual Control Panels?