CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO]next phase on HELP

on 2001-12-13 12:18:09 UTC
> OK! thanks to those who answered! this forum is just great!
> now i think i know what i have to do... but how to do it
>
> 1) what type of encoder? what do people typically do for encoders for the
> gecko's, i have only seen reference to servo motors with the encoder
> allready in it, what have the people on this list used?

You can get an encoder from USDigital that will probably screw right
up to your motor if you have a shaft sticking out the back and there are
some threaded holes on the plate to mount it to. That's what I did and the
holes were allready there. Prices are reasonable (about $50.00 each)
get the little centering tool they sell for about $10.00 and it goes on
easy. You will need the dimensions of the shaft to get the right disk.

Bill

Discussion Thread

dlantz@a... 2001-12-13 09:50:18 UTC [CAD_CAM_EDM_DRO]next phase on HELP Chris Clough 2001-12-13 10:36:24 UTC Dolphin PartMaster Chris Clough 2001-12-13 10:37:50 UTC RE: [CAD_CAM_EDM_DRO]next phase on HELP William Scalione 2001-12-13 12:18:09 UTC Re: [CAD_CAM_EDM_DRO]next phase on HELP follicely_challenged 2001-12-13 12:23:35 UTC Re: Dolphin PartMaster Chris Clough 2001-12-13 12:24:51 UTC RE: [CAD_CAM_EDM_DRO]next phase on HELP dlantz@a... 2001-12-13 12:49:30 UTC RE: [CAD_CAM_EDM_DRO]next phase on HELP William Scalione 2001-12-13 14:28:14 UTC Re: [CAD_CAM_EDM_DRO]next phase on HELP Chris Clough 2001-12-13 14:32:40 UTC RE: [CAD_CAM_EDM_DRO]next phase on HELP William Scalione 2001-12-13 15:11:10 UTC Re: [CAD_CAM_EDM_DRO]next phase on HELP