Re: [CAD_CAM_EDM_DRO] Gecko ERR/RES Handling

Thanks Tim, I was totally frustraded when I wrote the post last night. too
many conflicting drawings.

I am wanting to use the Gecko G320/G340 FAULT/RESET MANAGER circuit, that I
have a drawing of. I assume that I can still use a STDT Center Off switch as
a reset, and Estop with that circuit, applying the voltage from the switch to
the common ERR/RES terminals. Is the ERR/RES terminal to subject to line
noise problems, as it looks like it would be a good place to bring in a stop
signal from the machine EStop button.

I have one servo and Gecko 320 breadboarded on the bench now, and working
well.
I am really impressed on how the servo works compared to a regular DC motor.
My step signal source is a bit slow, so can't do speed but it works, and no
Magic smoke came out.
It looks like the servos that I have will be more than adequate for the
Compact 5 PC lathe, I have not tried them yet on the Sherline mill, but
hopefully soon. Have to make bushings for the small shafts on the motors.
Might try to get them made tonight.
bill