Re: EMC running at last!
Posted by
Dan Falck
on 1999-11-02 18:30:21 UTC
At 12:23 PM 11/2/1999 , you wrote:
I had the same problem with the Oct-18 release. It appeared to be a
problem with the limit switch polarity. Somehow I was able get the X out
of a "Red" condition (changed min_limit_polarity and max_limit_polarity to
0) but couldn't duplicate it with the Y and Z. So, I got tired of it all
and went back to the Oct-8th release and all appears to be fine now.
Granted this version is running on a computer in my den, while a really old
release from this last spring is running an actual machine fine.
Maybe Fred can shed some light on the estop problem.
Thanks,
Dan Falck
>From: Clint Bach <clintbach@...>Clint,
>
>Ian,
>
>No, nothing is plugged into the parallel port now. I need to make up a
>cable for my machine anyway so I will just do it. Curiosity says I will
>ground pin 13 before I do anything though... I'm not patient unless I
>absolutely have to be. This has stretched my patience farther than I
>would normally go!
>
>Clint
>
I had the same problem with the Oct-18 release. It appeared to be a
problem with the limit switch polarity. Somehow I was able get the X out
of a "Red" condition (changed min_limit_polarity and max_limit_polarity to
0) but couldn't duplicate it with the Y and Z. So, I got tired of it all
and went back to the Oct-8th release and all appears to be fine now.
Granted this version is running on a computer in my den, while a really old
release from this last spring is running an actual machine fine.
Maybe Fred can shed some light on the estop problem.
Thanks,
Dan Falck
Discussion Thread
Clint Bach
1999-11-02 06:14:03 UTC
EMC running at last!
Jon Elson
1999-11-02 10:38:49 UTC
Re: EMC running at last!
Ian Wright
1999-11-02 12:39:02 UTC
Re: EMC running at last!
Clint Bach
1999-11-02 10:23:34 UTC
Re: EMC running at last!
Dan Falck
1999-11-02 18:30:21 UTC
Re: EMC running at last!
Dan Falck
1999-11-02 19:21:09 UTC
Re: EMC running at last!
Matt Shaver
1999-11-02 19:41:41 UTC
Re: EMC running at last!
Dan Falck
1999-11-02 20:50:14 UTC
Re: EMC running at last!
Clint Bach
1999-11-03 02:55:10 UTC
Re: EMC running at last!