Re: EMC running at last!

I went back and reinstalled the Oct-18th release and it does work with the
MIN_LIMIT_SWITCH_POLARITY and MAX_LIMIT_SWITCH_POLARITY set to 0. If there
were limit switches actually installed, it would probably work with them
set to 1.
(This was all regarding the "not able to get out of ESTOP" condition that a
lot of us were having.)

Dan


At 08:30 PM 11/2/1999 , you wrote:

>From: Dan Falck <dfalck@...>
>
>At 12:23 PM 11/2/1999 , you wrote:
>>From: Clint Bach <clintbach@...>
>>
>>Ian,
>>
>>No, nothing is plugged into the parallel port now. I need to make up a
>>cable for my machine anyway so I will just do it. Curiosity says I will
>>ground pin 13 before I do anything though... I'm not patient unless I
>>absolutely have to be. This has stretched my patience farther than I
>>would normally go!
>>
>>Clint
>>
>
>
>Clint,
>
>I had the same problem with the Oct-18 release. It appeared to be a
>problem with the limit switch polarity. Somehow I was able get the X out
>of a "Red" condition (changed min_limit_polarity and max_limit_polarity to
>0) but couldn't duplicate it with the Y and Z. So, I got tired of it all
>and went back to the Oct-8th release and all appears to be fine now.
>Granted this version is running on a computer in my den, while a really old
>release from this last spring is running an actual machine fine.
>
>Maybe Fred can shed some light on the estop problem.
>
>Thanks,
>Dan Falck
>
>>Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the

discussion of shop built systems in the above catagories.

>To Unsubscribe, read archives, change to or from digest.
>Go to: http://www.onelist.com/isregistered.cgi
>Log on, and you will go to Member Center, and you can make changes there.
>For the FAQ, go to http://www.ktmarketing.com/faq.html
>bill,
>List Manager
>