CAD CAM EDM DRO - Yahoo Group Archive

Re: Thanks Mariss/Where are you!

on 2002-01-12 18:05:06 UTC
--- In CAD_CAM_EDM_DRO@y..., "mariss92705" <mariss92705@y...> wrote:
> I have a 160VDC prototype of the G320 that I occasionally run for
>my
> own amusement and it works very well indeed. However our lawyers
> warned us off from putting it in production for the previously
> mentioned reasons. We pay them the big bucks to see problems I
>cannot
> and they earned their money on that one.
>
> It disgusts me because it works so well (no xformer).
>
Mariss
It's unfortunate that this drive may never see the light of day.
What about a high amperage stepper drive for the big type 42 motors
out there?
As I understand it the 210's loose speed on a Bridgeport series 1 or
II and there are many out there.
I believe this was discussed at one time. Something like 80v at 12
amp would bring life back to a lot of machines out there, especially
with microstepping drives.
I have looked and so far haven't seen a drive to do this except the
Ahha original unit.

John S.

Discussion Thread

Multi-Volti Devices (Murray) 2002-01-10 05:49:02 UTC Thanks Mariss chewy8833 2002-01-10 15:40:10 UTC Re: Thanks Mariss/Where are you! mariss92705 2002-01-10 16:47:41 UTC Re: Thanks Mariss/Where are you! unterhausen 2002-01-10 18:46:08 UTC Re: Thanks Mariss/Where are you! Carol & Jerry Jankura 2002-01-10 18:56:52 UTC RE: [CAD_CAM_EDM_DRO] Re: Thanks Mariss/Where are you! mariss92705 2002-01-10 19:09:43 UTC Re: Thanks Mariss/Where are you! mariss92705 2002-01-10 19:35:03 UTC Re: Thanks Mariss/Where are you! Art Fenerty 2002-01-11 09:29:01 UTC Re: [CAD_CAM_EDM_DRO] Re: Thanks Mariss/Where are you! ccs@m... 2002-01-11 10:09:00 UTC Re: [CAD_CAM_EDM_DRO] Re: Thanks Mariss/Where are you! sprooney797 2002-01-11 15:32:22 UTC Re: Thanks Mariss/Where are you! Rich D. 2002-01-11 16:38:16 UTC Re: [CAD_CAM_EDM_DRO] Re: Thanks Mariss/Where are you! mariss92705 2002-01-11 16:44:31 UTC Re: Thanks Mariss/Where are you! Carlos Guillermo 2002-01-11 17:00:49 UTC RE: [CAD_CAM_EDM_DRO] Re: Thanks Mariss/Where are you! Sven Peter 2002-01-11 18:03:06 UTC Re: [CAD_CAM_EDM_DRO] Re: Thanks Mariss/Where are you! ballendo 2002-01-11 19:45:30 UTC Re: Thanks Mariss/Where are you! stevenson_engineers 2002-01-12 18:05:06 UTC Re: Thanks Mariss/Where are you!