Re: [CAD_CAM_EDM_DRO] Free Surfcam

I think it is 1000 lines...... I remember I could not even modify a new post
file by cut/copy/pasting without it telling me I exceeded the limit.

It also limits you to a maximum of two operations per toolpath generation
event. Then I am sure you can not merge them in Surfcams built in editor
because of the limit. Nothing keeps you from using a different editor though.

I don't really use it, I just wanted to see this version as I had only been
familiar with the older ones. It draws easy for a beginner, though I find it
draws too slow compared to other techniques. Cam Portion is very nice, but has
less than "easy" options for direct tweaking of a toolpath as compared to
VectorCam.

Chris L



glee@... wrote:

> I had seen an earlier post that indicated that there was a 100 line gcode
> limitation in the free surfcam. I do not know this for fact as I am using
> Dolphin.
>
> food for thought to check out
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/