CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] Free Surfcam

Posted by Chris L
on 2002-01-30 19:22:49 UTC
You are able to configure a post to fit your needs in the freeware. I did. Of
course I recalled a little info from doing it in the past. Its not sraight
forward but it can be made. I made one for my FlashCut controller.

Chris L

Doug Harrison wrote:

> > Anybody got the free surfcam CD yet and run it?
> > Any feed back good , bad etc
> >
> > John S.
> >
>
> A few days before it arrived I talked to the regional Surfcam rep.
> Apparently, they (like Mastercam) won't supply the information the customer
> needs to write posts. Thus, you have to pay them for this "service." I
> chucked the disk in the garbage when it showed up.
>
> I've used Surfcam and think it it good software. However, I avoid software
> that requires $150/hr maintenance calls.
>
> Doug
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this page: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Manager
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/

Discussion Thread

stevenson_engineers 2002-01-30 17:05:21 UTC Free Surfcam Doug Harrison 2002-01-30 18:47:43 UTC Re: [CAD_CAM_EDM_DRO] Free Surfcam Chris L 2002-01-30 19:22:49 UTC Re: [CAD_CAM_EDM_DRO] Free Surfcam Andy Olney 2002-01-30 21:34:04 UTC RE: [CAD_CAM_EDM_DRO] Free Surfcam Andy Olney 2002-01-30 21:39:11 UTC RE: [CAD_CAM_EDM_DRO] Free Surfcam glee@i... 2002-01-30 21:55:58 UTC RE: [CAD_CAM_EDM_DRO] Free Surfcam Chris L 2002-01-31 17:40:39 UTC Re: [CAD_CAM_EDM_DRO] Free Surfcam