Re: Circuit Board Layout Program

Hi Ian,

Yes! That would explain the larger numbers! And it reminds me that I
still haven't put in code for MM's. French Inches and Lignes. G20,
G21, Hummm, they must be G22 and G23 then.

Best regards from the "Imperial" side of the pond.

Alan KM6VV

"Ian W. Wright" wrote:

>
> ----- Original Message -----
> From: "Alan Marconett KM6VV"
> > I wonder if Ian had METRIC numbers (they looked too big
> > on my program)?
>
> Hi Alan,
>
> Yes, my file was metric. I'm afraid I don't use much else nowadays apart
> from a few French Inches and Lignes in watch work. This is the one bit of
> being 'european' that I do find useful and, since its becoming almost
> impossible to find nuts and bolts in anything other than metric sizes, its
> just easier to 'go with the flow'.
>
> Best wishes,
> Ian
> --
>
> Ian W. Wright
> Sheffield, UK