Re: [CAD_CAM_EDM_DRO] Using a tapping attachment with a CNC bore cycle
Posted by
Jon Anderson
on 2002-02-14 21:29:56 UTC
"Fitch R. Williams" wrote:
but it's not a problem. Part of the issue with tool changers would be
not wanting the torque arm to rotate through say, 270 degrees before
hitting the stop... Also would not be pretty if it tried to load the
torque arm into the stop. I'm not sure how tapping heads are keyed in
the tool change cycle, but in that case it's better to really constrain
things.
Jon
> I am guessing that since the spindle is always going in one direction, aShould be no problem. Sometimes the torque arm will bounce back a bit,
> single stop works fine?
but it's not a problem. Part of the issue with tool changers would be
not wanting the torque arm to rotate through say, 270 degrees before
hitting the stop... Also would not be pretty if it tried to load the
torque arm into the stop. I'm not sure how tapping heads are keyed in
the tool change cycle, but in that case it's better to really constrain
things.
Jon
Discussion Thread
Fitch R. Williams
2002-02-14 19:29:36 UTC
Using a tapping attachment with a CNC bore cycle
Jon Anderson
2002-02-14 19:39:43 UTC
Re: [CAD_CAM_EDM_DRO] Using a tapping attachment with a CNC bore cycle
Fitch R. Williams
2002-02-14 20:23:42 UTC
Re: [CAD_CAM_EDM_DRO] Using a tapping attachment with a CNC bore cycle
Jon Anderson
2002-02-14 21:29:56 UTC
Re: [CAD_CAM_EDM_DRO] Using a tapping attachment with a CNC bore cycle
Jon Elson
2002-02-14 22:16:47 UTC
Re: [CAD_CAM_EDM_DRO] Using a tapping attachment with a CNC bore cycle
Jon Elson
2002-02-14 22:30:15 UTC
Re: [CAD_CAM_EDM_DRO] Using a tapping attachment with a CNC bore cycle
Fitch R. Williams
2002-02-15 04:52:18 UTC
Re: [CAD_CAM_EDM_DRO] Using a tapping attachment with a CNC bore cycle
Fitch R. Williams
2002-02-15 05:15:13 UTC
Re: [CAD_CAM_EDM_DRO] Using a tapping attachment with a CNC bore cycle
Fitch R. Williams
2002-02-15 06:43:32 UTC
Re: [CAD_CAM_EDM_DRO] Using a tapping attachment with a CNC bore cycle
Jon Elson
2002-02-15 10:52:38 UTC
Re: [CAD_CAM_EDM_DRO] Using a tapping attachment with a CNC bore cycle
doug98105
2002-02-15 11:09:40 UTC
Re: Using a tapping attachment with a CNC bore cycle
Fitch R. Williams
2002-02-15 16:18:25 UTC
Re: [CAD_CAM_EDM_DRO] Using a tapping attachment with a CNC bore cycle
Jon Elson
2002-02-15 22:32:35 UTC
Re: [CAD_CAM_EDM_DRO] Re: Using a tapping attachment with a CNC bore cycle
Jon Elson
2002-02-15 22:52:32 UTC
Re: [CAD_CAM_EDM_DRO] Using a tapping attachment with a CNC bore cycle
Fitch R. Williams
2002-02-16 05:14:21 UTC
Re: [CAD_CAM_EDM_DRO] Re: Using a tapping attachment with a CNC bore cycle