Re: extrusion of Linear Bearing pillow block question...
Posted by
ballendo
on 2002-02-18 02:57:02 UTC
Hello,
Just came to my own post and find it a bit poorly written. Sorry
about that. Corrected the 2nd paragraph below: Additions in < >
Just came to my own post and find it a bit poorly written. Sorry
about that. Corrected the 2nd paragraph below: Additions in < >
--- In CAD_CAM_EDM_DRO@y..., "ballendo" <ballendo@y...> wrote:
Hello again,
As I posted before, many of the newer "round rail" type linear
bearings RELY on the bore of the HOUSING <they are mounted in> to
meet their specs!
The load is transfered <from the round rail, by the balls> to the
<load bearing> steel plates, which are held in POSITION by the
plastic housing <of the linear bearing itself>.
These steel plates in turn, bear upon the <walls of the> housing <the
linear bearing is placed into>. On Thomsons' super smart series,
these <steel> plates are "rounded" to allow for misalignment(s). The
down side is that this means EVEN MORE of the force is concentrated
on EVEN LESS area of the <bored hole of the> housing, making its'
precision/hardness even more important.
<rest of message okay so snipped here>
Discussion Thread
Lloyd Leung
2002-02-16 19:50:58 UTC
extrusion of Linear Bearing pillow block question...
dave_ace_me
2002-02-16 20:23:24 UTC
Re: extrusion of Linear Bearing pillow block question...
Chris L
2002-02-16 21:08:42 UTC
Re: [CAD_CAM_EDM_DRO] extrusion of Linear Bearing pillow block question...
wanliker@a...
2002-02-16 21:25:56 UTC
Re: [CAD_CAM_EDM_DRO] extrusion of Linear Bearing pillow block question...
Marcus & Eva
2002-02-17 08:31:19 UTC
Re: [CAD_CAM_EDM_DRO] extrusion of Linear Bearing pillow block question...
Smoke
2002-02-17 09:23:11 UTC
Re: [CAD_CAM_EDM_DRO] extrusion of Linear Bearing pillow block question...
Randy Gordon-Gilmore
2002-02-17 10:04:05 UTC
Re: [CAD_CAM_EDM_DRO] extrusion of Linear Bearing pillow block question...
Chris L
2002-02-17 10:22:16 UTC
Re: [CAD_CAM_EDM_DRO] extrusion of Linear Bearing pillow block question...
Andy Olney
2002-02-17 12:50:03 UTC
RE: [CAD_CAM_EDM_DRO] extrusion of Linear Bearing pillow block question...
Chris L
2002-02-17 13:11:50 UTC
Re: [CAD_CAM_EDM_DRO] extrusion of Linear Bearing pillow block question...
aspaguy
2002-02-17 14:17:21 UTC
Re: extrusion of Linear Bearing pillow block question...
wanliker@a...
2002-02-17 15:15:33 UTC
Re: [CAD_CAM_EDM_DRO] Re: extrusion of Linear Bearing pillow block question...
ballendo
2002-02-17 23:57:42 UTC
Re: extrusion of Linear Bearing pillow block question...
ballendo
2002-02-18 02:57:02 UTC
Re: extrusion of Linear Bearing pillow block question...