I'm looking for a source of eccentric bushings.
Posted by
Lloyd Leung
on 2002-02-21 00:00:18 UTC
Eccentric bushings are like bushings, except the inner hole is off
centered (eccentric)
I know I could make them, however I'm trying to find a supplier that
already has them for sale.
I looked at mcmaster.com, and tried to google it...
I've found lots of eccentric washers... and roller blade eccentric
spacers (which may work, but are flanged).
I'm looking for a spacer/bushing of the following features:
- 1/2" OD
- 1/4" ID.
- 1/4" to 1/2" thick. (I hope I can choose or something).
This would be used to adjust bearings/cam followers. I know that there
are eccentric cam-followers. However they're expensive, when I need
quite a few of them. So, eccentric spacer, bolt, and standard radial
bearing = cheap. :)
Cheap is good, when it does the same job.
If anyone knows where I can find some for sale, it would be greatly
appreciated.
Thanks.
--
Lloyd Leung
Lloyd@...
centered (eccentric)
I know I could make them, however I'm trying to find a supplier that
already has them for sale.
I looked at mcmaster.com, and tried to google it...
I've found lots of eccentric washers... and roller blade eccentric
spacers (which may work, but are flanged).
I'm looking for a spacer/bushing of the following features:
- 1/2" OD
- 1/4" ID.
- 1/4" to 1/2" thick. (I hope I can choose or something).
This would be used to adjust bearings/cam followers. I know that there
are eccentric cam-followers. However they're expensive, when I need
quite a few of them. So, eccentric spacer, bolt, and standard radial
bearing = cheap. :)
Cheap is good, when it does the same job.
If anyone knows where I can find some for sale, it would be greatly
appreciated.
Thanks.
--
Lloyd Leung
Lloyd@...
Discussion Thread
Lloyd Leung
2002-02-21 00:00:18 UTC
I'm looking for a source of eccentric bushings.
Mark Ehle
2002-02-21 04:39:54 UTC
Re: [CAD_CAM_EDM_DRO] I'm looking for a source of eccentric bushings.
Lloyd Leung
2002-02-21 05:06:16 UTC
RE: [CAD_CAM_EDM_DRO] I'm looking for a source of eccentricbushings.
Smoke
2002-02-21 11:19:08 UTC
Re: [CAD_CAM_EDM_DRO] I'm looking for a source of eccentricbushings.
ballendo
2002-02-22 03:44:17 UTC
Re: I'm looking for a source of eccentric bushings.