CAD CAM EDM DRO - Yahoo Group Archive

If I have a Gecko G201 what's my shopping list?

Posted by Lloyd Leung
on 2002-03-14 06:57:17 UTC
What exactly is needed, if I already have:
-stepper motors
-Two DC 4v, 1.1A (6 wire) (2 phase)
-Three DC 4.5, 1.4A (6 wire) (unknown phase, probably 2 phase)

-G201 drivers already...

My shopping list is so far...
- Power supply (between +24 to 80 VDC) (do I need a separate power
supply for each drive/motor combo)?

- 470 uF capacitor (if more than a foot away from the power source)
- question about this, do I need a separate capacitor for each
drive?


- Wire to connect them all (12, 18, 22 gauges)
- Something to hold them all the setup in place (sheet metal, plastic,
whatever works)

Anyone have a nice three or 4 axis wiring diagram that could share?

Discussion Thread

Lloyd Leung 2002-03-14 06:57:17 UTC If I have a Gecko G201 what's my shopping list? Tim Goldstein 2002-03-14 07:50:12 UTC Re: [CAD_CAM_EDM_DRO] If I have a Gecko G201 what's my shopping list? snuckleton 2002-03-14 20:03:46 UTC Re: If I have a Gecko G201 what's my shopping list? Tim Goldstein 2002-03-14 23:18:48 UTC RE: [CAD_CAM_EDM_DRO] If I have a Gecko G201 what's my shopping list? snuckleton 2002-03-15 05:17:30 UTC Re: If I have a Gecko G201 what's my shopping list? n4onl 2002-03-15 17:24:34 UTC Re: If I have a Gecko G201 what's my shopping list?