question for potential Gecko 320/340 users
Posted by
Steve Stallings
on 2002-03-25 09:55:29 UTC
I am in the process of finalizing the design for an
interface board that provides, among other things,
an isolated, buffered feedback from the Gecko 320/340
step-servo drivers. Since this signal is different
from other feedback and cannot be interchanged with
plain contact closure inputs, where should it show
up on the parallel port?
It would be useful to hear from users of EMC, Master5,
TurboCNC, CNCPro, MaxNC, and any other systems. If
you prefer, or if you have trouble posting to Yahoo,
you can reply to stevesng (at) newsguy (dot) com.
Thanks,
Steve Stallings
interface board that provides, among other things,
an isolated, buffered feedback from the Gecko 320/340
step-servo drivers. Since this signal is different
from other feedback and cannot be interchanged with
plain contact closure inputs, where should it show
up on the parallel port?
It would be useful to hear from users of EMC, Master5,
TurboCNC, CNCPro, MaxNC, and any other systems. If
you prefer, or if you have trouble posting to Yahoo,
you can reply to stevesng (at) newsguy (dot) com.
Thanks,
Steve Stallings
Discussion Thread
Steve Stallings
2002-03-25 09:55:29 UTC
question for potential Gecko 320/340 users
Steve Stallings
2002-03-25 09:59:23 UTC
RE: question for potential Gecko 320/340 users
beer@s...
2002-03-25 10:37:58 UTC
RE: question for potential Gecko 320/340 users
Alan Marconett KM6VV
2002-03-25 10:57:57 UTC
Re: [CAD_CAM_EDM_DRO] question for potential Gecko 320/340 users
Jon Elson
2002-03-25 11:04:09 UTC
Re: [CAD_CAM_EDM_DRO] question for potential Gecko 320/340 users
Jon Elson
2002-03-25 11:10:37 UTC
Re: [CAD_CAM_EDM_DRO] RE: question for potential Gecko 320/340 users
stephen_stallings
2002-03-27 11:36:06 UTC
Re: question for potential Gecko 320/340 users - updated
Steve Stallings
2002-03-29 02:16:05 UTC
RE: question for potential Gecko 320/340 users - updated
dkowalcz2000
2002-03-30 15:24:05 UTC
Re: question for potential Gecko 320/340 users - updated
ballendo
2002-04-06 07:26:57 UTC
Re: question for potential Gecko 320/340 users - updated