Re: Distractions....

Oops forgot to tell you to look under MISCELLANEOUS.
Darrell

----- Original Message -----
From: Darrell <dgehlsen@...>
To: <CAD_CAM_EDM_DRO@onelist.com>
Sent: Wednesday, December 22, 1999 3:21 PM
Subject: Re: [CAD_CAM_EDM_DRO] Distractions....


> From: "Darrell" <dgehlsen@...>
>
> There is a good article here : http://www.mindspring.com/~wgray1/
>
> Darrell
>
> ----- Original Message -----
> From: David L Anderson <daveland@...>
> To: <CAD_CAM_EDM_DRO@onelist.com>
> Sent: Wednesday, December 22, 1999 3:45 PM
> Subject: [CAD_CAM_EDM_DRO] Distractions....
>
>
> > From: David L Anderson <daveland@...>
> >
> > Matt
> >
> > Yup.. I thought about it too. One machine to rebuild in the garage is
> > more than enough ( so says my
> > wife!!!!). So now I go to the junk yard and strip off two more Yaskawa
> > motors.... One for the Z axis
> > and one for a spare. Then to figure out how to build a 3 phase
> > converter out of a 5hp 3 phase motor.
> > Know of any resources for rotory 3 phase converter design???
> >
> > dave
> >
> > > Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
> discussion of shop built systems in the above catagories.
> > To Unsubscribe, read archives, change to or from digest.
> > Go to: http://www.onelist.com/isregistered.cgi
> > Log on, and you will go to Member Center, and you can make changes
there.
> > For the FAQ, go to http://www.ktmarketing.com/faq.html
> > bill,
> > List Manager
> >
>
> > Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems in the above catagories.
> To Unsubscribe, read archives, change to or from digest.
> Go to: http://www.onelist.com/isregistered.cgi
> Log on, and you will go to Member Center, and you can make changes there.
> For the FAQ, go to http://www.ktmarketing.com/faq.html
> bill,
> List Manager
>