Mariss? Dan M? Re: Bill W's question?
Posted by
ballendo
on 2002-04-17 05:03:29 UTC
Hello,
Did I miss the answer(s)?
A bit ago Bill W (list mom) asked you two what I thought was a very
good question: (paraphrased below)
"What is the best way to handle you drive(s) in an estop situation"
I'd add: Let's assume there is some mass, say 100 lbs. plus. Let's
also assume this mass is currently in the middle of a multi axis move
at something around(at least) 100IPM.
So the question is, What are your recommendations? How do we wire for
estop so that we can meet safety standards, while not destroying
Your/the drives in the process(if possible)?
Thank you both in advance,
Ballendo
P.S. Although Bill W named Mariss and Dan Mauch specifically, I'd
appreciate input/answers from others who are selling drives... Dave
R, Dean, Bill, Doug(your non-geckos, obviously), etc.?
Did I miss the answer(s)?
A bit ago Bill W (list mom) asked you two what I thought was a very
good question: (paraphrased below)
"What is the best way to handle you drive(s) in an estop situation"
I'd add: Let's assume there is some mass, say 100 lbs. plus. Let's
also assume this mass is currently in the middle of a multi axis move
at something around(at least) 100IPM.
So the question is, What are your recommendations? How do we wire for
estop so that we can meet safety standards, while not destroying
Your/the drives in the process(if possible)?
Thank you both in advance,
Ballendo
P.S. Although Bill W named Mariss and Dan Mauch specifically, I'd
appreciate input/answers from others who are selling drives... Dave
R, Dean, Bill, Doug(your non-geckos, obviously), etc.?
Discussion Thread
ballendo
2002-04-17 05:03:29 UTC
Mariss? Dan M? Re: Bill W's question?
Peter Seddon
2002-04-17 09:53:13 UTC
Re: [CAD_CAM_EDM_DRO] Mariss? Dan M? Re: Bill W's question?
mariss92705
2002-04-17 18:21:02 UTC
Mariss? Dan M? Re: Bill W's question?
Jon Elson
2002-04-18 04:42:00 UTC
Re: [CAD_CAM_EDM_DRO] Mariss? Dan M? Re: Bill W's question?
ballendo
2002-04-19 06:14:33 UTC
Mariss? Dan M? Re: Bill W's question?
mariss92705
2002-04-19 08:39:10 UTC
Mariss? Dan M? Re: Bill W's question?