Re: [CAD_CAM_EDM_DRO] Mariss? Dan M? Re: Bill W's question?

The health and safety people would expect power to be removed from the
drives under e-stop as it could be a runaway that caused the problem. Would
this potentially destroy the drive - possibly it would lock the slide
assembly.

Regards Peter

----- Original Message -----
From: "ballendo" <ballendo@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Wednesday, April 17, 2002 7:07 AM
Subject: [CAD_CAM_EDM_DRO] Mariss? Dan M? Re: Bill W's question?


> Hello,
>
> Did I miss the answer(s)?
>
> A bit ago Bill W (list mom) asked you two what I thought was a very
> good question: (paraphrased below)
>
> "What is the best way to handle you drive(s) in an estop situation"
>
> I'd add: Let's assume there is some mass, say 100 lbs. plus. Let's
> also assume this mass is currently in the middle of a multi axis move
> at something around(at least) 100IPM.
>
> So the question is, What are your recommendations? How do we wire for
> estop so that we can meet safety standards, while not destroying
> Your/the drives in the process(if possible)?
>
> Thank you both in advance,
>
> Ballendo
>
> P.S. Although Bill W named Mariss and Dan Mauch specifically, I'd
> appreciate input/answers from others who are selling drives... Dave
> R, Dean, Bill, Doug(your non-geckos, obviously), etc.?
>
>
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
>
> OFF Topic POSTS: General Machining
> If you wish to post on unlimited OT subjects goto:
aol://5863:126/rec.crafts.metalworking or go thru Google.com to reach it if
you have trouble.
> http://www.metalworking.com/news_servers.html
>
> http://groups.yahoo.com/group/jobshophomeshop I consider this as a
sister site to the CCED group, as many of the same members are there, for OT
subjects, that are not allowed on the CCED list.
>
>
>
> Post messages: CAD_CAM_EDM_DRO@yahoogroups.com
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...
> Moderator: jmelson@... timg@... [Moderator]
> URL to this group: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
> bill,
> List Mom
> List Owner
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>
>
>