Re: [CAD_CAM_EDM_DRO].9 deg/step motor
Posted by
RichD
on 2002-04-19 14:07:43 UTC
Jeff,
Vexta wire colors are hard to see on some motors. The orange and brown
are almost alike.
Also, hook up only one coil on each side only at first to sort out
the directions and correct conections then try the other 2 coils alone.
There is only one way they will run correctly.
RichD
jeffdavis516 wrote:
Vexta wire colors are hard to see on some motors. The orange and brown
are almost alike.
Also, hook up only one coil on each side only at first to sort out
the directions and correct conections then try the other 2 coils alone.
There is only one way they will run correctly.
RichD
jeffdavis516 wrote:
>
> If I can believe the sketch that came with the motors then I have it
> wired correctly. I will compare your color chart for the PK series
> when I get home tonight. It could be that the chart is wrong.
>
> Thanks
>
> Jeff Davis
> http://www.homecnc.info
>
> --- In CAD_CAM_EDM_DRO@y..., RichD <cmsteam@s...> wrote:
> > Jeff,
> > I'm sure you don't have it connected correctly.
> > Anytime it just rattles back & forth or runs either way regardless.
> > The diagram I have shows:
> > For PH series-
> > A+black
> > A-yellow
> > a+orange
> > a-green
> > B+red
> > B-white
> > b+brown
> > b-blue
> >
> > For PK series-
> > A+black
> > A-black/white
> > a+orange/white
> > a-orange
> > B+red
> > B-red/white
> > b+yellow/white
> > b-yellow
> >
> > RichD
Discussion Thread
jeffdavis516
2002-04-18 22:46:03 UTC
.9 deg/step motor
RichD
2002-04-18 23:14:47 UTC
Re: [CAD_CAM_EDM_DRO] .9 deg/step motor
Carol & Jerry Jankura
2002-04-19 05:56:24 UTC
RE: [CAD_CAM_EDM_DRO] .9 deg/step motor
Alan Marconett KM6VV
2002-04-19 11:06:29 UTC
Re: [CAD_CAM_EDM_DRO] .9 deg/step motor
jeffdavis516
2002-04-19 11:10:57 UTC
Re: .9 deg/step motor
Jon Elson
2002-04-19 13:57:56 UTC
Re: [CAD_CAM_EDM_DRO] .9 deg/step motor
RichD
2002-04-19 14:07:43 UTC
Re: [CAD_CAM_EDM_DRO].9 deg/step motor
Brian
2002-04-19 17:01:02 UTC
Re: [CAD_CAM_EDM_DRO] .9 deg/step motor
jeffdavis516
2002-04-22 23:15:51 UTC
Re: .9 deg/step motor
tonyjeffree
2002-04-22 23:49:32 UTC
Re: .9 deg/step motor
Jon Elson
2002-04-23 10:10:03 UTC
Re: [CAD_CAM_EDM_DRO] Re: .9 deg/step motor