CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] More Re: Drive mfrs recommendations for MOTOR cables ?

Posted by jim davies
on 2002-04-30 16:39:55 UTC
> Should we crimp AND solder, or
> > just crimp? Or just solder? What are the tradeoffs?
>
> All connectors on large commercial aircraft are crimped only.
> This I am told, is because the solder will wick up the wire under
> the insulation a bit and that part will not be flexible, which can
> then break. Of course we also use $350.00 calibrated crimpers
> and $100.00 (and up) circular connectors. Something, I'm sure
> most home shop guys don't use. I know I sure don't.
>
The same can be said about automotive OE connectors. None are
soldered but the crimping tool and connectors are not the commonly
available ones. They are not as pricey as aircraft, so would be worth
looking for. OTOH, soldered connectors if done properly are great
[IMO] in a non-vibration situation.

Discussion Thread

jbolt001 2002-04-23 21:10:43 UTC Yet another power supply question RichD 2002-04-23 21:39:03 UTC Re: [CAD_CAM_EDM_DRO] Yet another power supply question mariss92705 2002-04-23 21:43:54 UTC Re: Yet another power supply question jbolt001 2002-04-24 13:11:18 UTC Re: Yet another power supply question mariss92705 2002-04-24 13:27:12 UTC Re: Yet another power supply question ballendo 2002-04-26 01:52:28 UTC Drive mfrs recommendations for MOTOR cables ? batwings@i... 2002-04-26 04:28:00 UTC Re: [CAD_CAM_EDM_DRO] Drive mfrs recommendations for MOTOR cables ? mariss92705 2002-04-26 10:18:54 UTC Re: Drive mfrs recommendations for MOTOR cables ? JanRwl@A... 2002-04-27 16:52:49 UTC Re: [CAD_CAM_EDM_DRO] Drive mfrs recommendations for MOTOR cables ? ballendo 2002-04-28 04:03:22 UTC More Re: Drive mfrs recommendations for MOTOR cables ? dave_ace_me 2002-04-28 07:23:13 UTC More Re: Drive mfrs recommendations for MOTOR cables ? mariss92705 2002-04-28 09:21:02 UTC More Re: Drive mfrs recommendations for MOTOR cables ? steveggca 2002-04-28 16:24:12 UTC More Re: Drive mfrs recommendations for MOTOR cables ? Peter 2002-04-29 12:17:26 UTC Re: [CAD_CAM_EDM_DRO] More Re: Drive mfrs recommendations for MOTOR cables ? William Scalione 2002-04-30 08:05:12 UTC Re: [CAD_CAM_EDM_DRO] More Re: Drive mfrs recommendations for MOTOR cables ? jim davies 2002-04-30 16:39:55 UTC Re: [CAD_CAM_EDM_DRO] More Re: Drive mfrs recommendations for MOTOR cables ? steveggca 2002-04-30 17:20:26 UTC More Re: Drive mfrs recommendations for MOTOR cables ? Paul R. Hvidston 2002-04-30 17:43:40 UTC Re: [CAD_CAM_EDM_DRO] More Re: Drive mfrs recommendations for MOTOR cables ?