Re: [CAD_CAM_EDM_DRO] CNC
Posted by
Jon Elson
on 2002-05-08 22:03:31 UTC
Gene wrote:
that speed is crashing it, go to 120%. You should get a following error
dialog box if the following error limits are exceeded. If you are having
this problem, reduce the acceleration parameters in the .ini file.
To set your coordinate system, use G92 X0 in MDI mode, or there is
a mouse function (right click over the axis) that brings up a menu to
set the axis relative coordinates.
> I've got my machine moving around pretty darn good now, it repeats toYou could try running it at 50% or 70% feedrate override, or to make sure
> under .002 which is the amount of the backlash. I'm having a problem
> with the EMC 3Dtest. sometimes it works good and some times it Quits
> before its done. The e-stop reset comes on. Could the speed be to high?
> Also trying to figure out to set the display to zero after you move the
> table and without going thru the home routine.
that speed is crashing it, go to 120%. You should get a following error
dialog box if the following error limits are exceeded. If you are having
this problem, reduce the acceleration parameters in the .ini file.
To set your coordinate system, use G92 X0 in MDI mode, or there is
a mouse function (right click over the axis) that brings up a menu to
set the axis relative coordinates.
Discussion Thread
WBHINKLE@x...
1999-05-09 09:25:47 UTC
CNC
Mike Chaney
1999-05-14 19:11:10 UTC
Re: CNC
WBHINKLE@x...
1999-05-15 07:25:35 UTC
Re: CNC
Gene
2002-05-08 21:23:51 UTC
CNC
Tim Goldstein
2002-05-08 21:38:41 UTC
RE: [CAD_CAM_EDM_DRO] CNC
Jon Elson
2002-05-08 22:03:31 UTC
Re: [CAD_CAM_EDM_DRO] CNC
Ray Henry
2002-05-09 13:15:04 UTC
Re: RE: CNC
v68442
2007-07-29 05:41:25 UTC
CNC
Graham Stabler
2007-07-29 05:53:38 UTC
Re: CNC
Jon Elson
2007-07-29 10:42:37 UTC
Re: [CAD_CAM_EDM_DRO] CNC
caudlet
2007-07-29 17:22:53 UTC
Re: CNC
v68442
2007-08-13 06:59:44 UTC
Re: CNC
Jon Elson
2007-08-13 09:04:52 UTC
Re: [CAD_CAM_EDM_DRO] Re: CNC
Peter Rosenholm
2007-08-13 13:26:38 UTC
Re: [CAD_CAM_EDM_DRO] Re: CNC