CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO]ENCO conversion

Posted by kdoney_63021
on 2002-05-17 13:25:30 UTC
These prices where for a 9X42 mill.

--- In CAD_CAM_EDM_DRO@y..., "kdoney_63021" <kdoney_63021@y...> wrote:
> PC Controller - EMC - linux, free <-- no threading
> or TurboCAD - freeware but registration is $20 <-- threading, DOS
> Ballscrews and yoke - HiWin $550 (2 axis) <-- drive the knee
> Motors - $450 - 3 ea PMDC
> Power Supply - $200 -
> Motor Drivers - $360 - 3 ea Gecko 320
> Wiring - $30
> Gearing and other hardware - $100
>
> No limit switches, emergency stop, coolant control, CAD software.
>
>
> --- In CAD_CAM_EDM_DRO@y..., "Bob Campbell" <bob@c...> wrote:
> > I have been asked by a local high school to help them convert an
> ENCO mill
> > to CNC.
> >
> > They are in the budget phase. What is a good budget figure to
work
> with.
> >
> > Bob Campbell

Discussion Thread

Joel Madden 2002-05-16 19:14:21 UTC Re: BP conversion.. Bob Campbell 2002-05-17 08:25:48 UTC [CAD_CAM_EDM_DRO]ENCO conversion kdoney_63021 2002-05-17 09:38:56 UTC Re: [CAD_CAM_EDM_DRO]ENCO conversion kdoney_63021 2002-05-17 13:25:30 UTC Re: [CAD_CAM_EDM_DRO]ENCO conversion bwrfromuk 2002-05-17 15:25:49 UTC Re: [CAD_CAM_EDM_DRO]ENCO conversion JanRwl@A... 2002-05-17 19:40:52 UTC Re: [CAD_CAM_EDM_DRO]ENCO conversion