Re: [CAD_CAM_EDM_DRO]ENCO conversion
Posted by
JanRwl@A...
on 2002-05-17 19:40:52 UTC
New bipolar motors and fine Gecko drives and a good, if kludged,
power-supply, and PC control, rather than a huge '60's BP "computer"??? If
very clever, and "labor" is not a factor, perhaps $1500. Probably more like
$4000, or even more, particularly if some interface circuitry must be BOUGHT,
rather than made "in-house".
power-supply, and PC control, rather than a huge '60's BP "computer"??? If
very clever, and "labor" is not a factor, perhaps $1500. Probably more like
$4000, or even more, particularly if some interface circuitry must be BOUGHT,
rather than made "in-house".
Discussion Thread
Joel Madden
2002-05-16 19:14:21 UTC
Re: BP conversion..
Bob Campbell
2002-05-17 08:25:48 UTC
[CAD_CAM_EDM_DRO]ENCO conversion
kdoney_63021
2002-05-17 09:38:56 UTC
Re: [CAD_CAM_EDM_DRO]ENCO conversion
kdoney_63021
2002-05-17 13:25:30 UTC
Re: [CAD_CAM_EDM_DRO]ENCO conversion
bwrfromuk
2002-05-17 15:25:49 UTC
Re: [CAD_CAM_EDM_DRO]ENCO conversion
JanRwl@A...
2002-05-17 19:40:52 UTC
Re: [CAD_CAM_EDM_DRO]ENCO conversion