Re: SLO-SYN 12.7 Amp motors

Sorry I don't have any thimng that will drive 12 amps. You may want to look
at the ahha controller . It will run 12 amps.
Dan
-----Original Message-----
From: Charles Hopkins <chopkins@...>
To: 'CAD_CAM_EDM_DRO@onelist.com' <CAD_CAM_EDM_DRO@onelist.com>
Date: Sunday, January 09, 2000 4:50 PM
Subject: [CAD_CAM_EDM_DRO] SLO-SYN 12.7 Amp motors

>From: Charles Hopkins <chopkins@...>
>
>I have a Bridgeport which has been fitted with SLO-SYN 1.75 volt 12.7 amp

stepper motors on all three axis. They are 200 steps/rev and set at 1 to 1
ratio to the ball screws

>
>How much power supply do I need to drive these motors and where can I buy

them.

>
>I also need drivers which will interface with EMC software.
>
>I have the machine with motors mounted and I have a 166 MHz computer with

EMC loaded. I need everything in between!

>
>I know there are a few who have plenty of experience with this topic. I am

ready for some suggestions on the hardware needs and just where I should
look to find what I need. I have a head start as this machine was running
as a CNC. I don't have much left of the original control as they were
stripping the machine and sending the parts out in the dumpster. The
machine came to me as scrap, but it is very good iron. I just need to give
it a new control. I have the old power supplies, but I think an upgrade is
warranted here.

>
>I am not too educated in this area, so let me have it in terms for a

beginner.

>
>I have a Bridgeport which I converted using the AH-ha system. I want to

try and set this one up running linux and EMC.

>
>Thanks
>
>Charles Hopkins
>
>
>--------------------------- ONElist Sponsor ----------------------------
>
>Get great offers on top-notch products that match your interests!
>Sign up for eLerts at:
><a href=" http://clickme.onelist.com/ad/elerts1 ">Click Here</a>
>
>------------------------------------------------------------------------
>
>Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the

discussion of shop built systems in the above catagories.

>To Unsubscribe, read archives, change to or from digest.
>Go to: http://www.onelist.com/isregistered.cgi
>Log on, and you will go to Member Center, and you can make changes there.
>For the FAQ, go to http://www.ktmarketing.com/faq.html
>bill,
>List Manager
>