CAD CAM EDM DRO - Yahoo Group Archive

Re: [CAD_CAM_EDM_DRO] G-Code

on 2002-05-26 15:33:50 UTC
Hi Randy,

So you're saying the output resolution had been set to 1? Good ketch!
I've been following the thread, as I have the program, and didn't pick
up on that!

Alan KM6VV

Randy Gordon-Gilmore wrote:
>
> At 10:46 AM 5/26/02 -1000, Gene wrote:
>
> >N5 X-3 Y1
>
> Ah, this I know! Go to Create / Set Parameters / Dec. Places and change
> from 0 to 4.
>
> That should fix it. (I remember having the same problem the first time I
> tried it, now that I see your output fragment...)
>
> Best regards,
>
> Randy

Discussion Thread

Art Fenerty 2000-09-02 10:24:29 UTC G-Code Gene 2002-05-26 09:43:03 UTC G-Code William Scalione 2002-05-26 10:12:20 UTC Re: [CAD_CAM_EDM_DRO] G-Code Gene 2002-05-26 10:25:25 UTC Re: [CAD_CAM_EDM_DRO] G-Code William Scalione 2002-05-26 10:38:36 UTC Re: [CAD_CAM_EDM_DRO] G-Code Gene 2002-05-26 11:04:29 UTC Re: [CAD_CAM_EDM_DRO] G-Code William Scalione 2002-05-26 11:17:36 UTC Re: [CAD_CAM_EDM_DRO] G-Code Gene 2002-05-26 13:47:06 UTC Re: [CAD_CAM_EDM_DRO] G-Code John Guenther 2002-05-26 14:33:21 UTC RE: [CAD_CAM_EDM_DRO] G-Code William Scalione 2002-05-26 14:48:06 UTC Re: [CAD_CAM_EDM_DRO] G-Code Randy Gordon-Gilmore 2002-05-26 15:27:50 UTC Re: [CAD_CAM_EDM_DRO] G-Code Alan Marconett KM6VV 2002-05-26 15:33:50 UTC Re: [CAD_CAM_EDM_DRO] G-Code Gene 2002-05-26 15:38:55 UTC Re: [CAD_CAM_EDM_DRO] G-Code Gene 2002-05-26 15:57:23 UTC Re: [CAD_CAM_EDM_DRO] G-Code William Scalione 2002-05-26 16:26:54 UTC Re: [CAD_CAM_EDM_DRO] G-Code Gene 2002-05-26 18:16:38 UTC Re: [CAD_CAM_EDM_DRO] G-Code Jon Elson 2002-05-26 23:08:45 UTC Re: [CAD_CAM_EDM_DRO] G-Code Carol & Jerry Jankura 2002-05-27 06:38:20 UTC RE: [CAD_CAM_EDM_DRO] G-Code